Avoiding Unwanted Ignition Incidents
By Dan Hlawati

There are two types of unwanted ignition incidents that can occur when using oxyfuel torches; backfire and flashback. There are two types of backfire; backfire itself and sustained backfire.

When oxygen is added to fuel gas it accelerates the burning rate of the gas, for example acetylene and oxygen burn at about 26 feet per second and alternate fuel gases (propane, natural gas, MAPP, or propylene) and oxygen burn somewhere in the 14 to 16 feet per second range. A backfire occurs when the flow of fuel gas, burning at the tip end with the support of oxygen, is reduced to a point where the burning rate overtakes the flow rate and backfires into the tip or torch, usually to where the fuel gas and oxygen are mixed. This is very audible when using large multi flames and the user turns the fuel gas off before the oxygen and hears a loud bang� noise. The noise is created by the flame backfiring into the mixer. There are times when the backfire continues to burn in the mixer area supported by the flow of fuel gas and oxygen. This is generally accompanied by a loud whistle noise and is termed sustained backfire�. A check valve, or a flash arrestor, will prevent a backfire or sustained backfire.

Flashback, on the other hand, is the ignition of mixed gases that develop in either the fuel gas or oxygen passages. This occurs when one or more of several situations develop while using a torch. It can result during a sustained backfire, when systems are over pressurized for the size tip being used, the tip is plugged or dirty, the oxygen or fuel gas supply depletes or results due to operator procedural error. When fuel gas backs into the oxygen line or oxygen into the fuel gas line the mixture can travel through the torch, into the hose, through the regulator and into the supply cylinder or system. The volume involved represents a very dangerous situation if ignited. Reverse flow check valves at the torch help prevent the reverse flow of gases however they are mechanical devices and may malfunction. They are designed to permit gases to reverse flow. That is the reason reverse flow check valves are recommended upstream of the flash arrestors. The flash arrestors will stop the ignition of the mixed gases even if the reverse flow check valve malfunctions. The result is the ignition cannot ignite into the hose, regulator, supply cylinder or system. Ignition does take place in the torch as it does with a backfire.

This is dangerous but as a general rule the torch design will withstand the ignition and will not throw parts or melt unless there is sustained ignition without operator intervention.

Therefore it is recommended that both reverse flow check valves and flash arrestors be used at the rear of the torch.

An additional word of caution, use of multiple check valves and/or flash arrestor, etc can restrict the forward flow of fuel gases contributing to backfires or in some cases reverse flows that ignite. Make certain to read and follow all operation instructions before using oxyfuel apparatus.

Click here to take the Learn & Win quiz. Answer correctly and you'll be entered to win a $100 gift card from Bass Pro Shops